Anchor Rollers

 The roller assembly I first bought was designed for a reefable bowsprit. Too big and too heavy.  I cut a 6 inch piece off the tail to bolt to the bow.

The plate will extend outboard to capture each roller. The slots in each roller cheek engages the  plate thereby fixing the angle so the Rocna anchor will ride below the bow sprit. The tail end of each PTF roller had to be trimmed to match up with the angle of the bow and the cover board was planed down so the gammon iron position did not change. 

The anchor roller bails would be fine for an all chain rode but the sharp edges will chafe through anything else.

Gammon iron and rollers.

Plate through bolted to bow. 

The rollers dry fitted on plate.



Sprit heel through bolts deck and stainless steel backing plate.